Over on YouTube, Leif (SM5BSZ) has uploaded a video where he shows how the Airspy HF+ can be used as an accurate power meter for RF signals. Leif notes that if the noise figure (NF) or minimum discernible signal (MDS) of an SDR is known, then it is possible to use that SDR as a power meter by calibrating it with a resistor (dummy load) at room temperature. To determine power levels Leif uses the signal diagnostics plugin which is built into SDR#. He writes in the video description:
When the noise figure (NF) or minimum discernible signal (MDS) of a software defined radio (SDR) is known we can use that radio as a power meter just by calibrating it on a room temperature resistor. Here the Airspy HF+ is used to demonstrate the principles. Note that MDS depends on the temperature. Manufacturer data is for a warmed up unit. Cold units have significantly lower MDS. Note the observations on bad adapters and attenuators towards the end of the video. One conclusion is that the HF+ is EXCELLENT in keeping common mode currents on the USB as well as on the antenna cable outside. They do not enter the receiver provided that the nut holding the SMA connector is firmly tightened.
In another video Leif also tests out a pre-production version of a HF+ preselector currently being designed by Youssef (designer of the HF+) by measuring the filter responses.
The post Using the Airspy HF+ as a Power Meter By Calibrating it with a Resistor appeared first on rtl-sdr.com.